WINDSOCK FRAMES

Our windsock frames are manufactured with ease of installation in mind.

ZP Series

We affectionately refer to this frame as our “economy frame.” Offered in the 6” and 10” diameters, this zinc-plated frame is a favorite for the aviation enthusiast. Just slip it over a ¾” rod or water pipe, with a flat washer underneath, and you are ready to go.

---

BF Series

These frames are one of our most popular among aviation enthusiasts as well as general aviation professionals. Manufactured from ¼” cold rolled steel and designed for many years of service. The frames are zinc plated for a long-lasting, chrome like finish. A machined bearing is added that allows the windsock to respond to the slightest wind. All you need for installation is a ½” collar looking up from your mast. We have four sizes to choose from – 6”, 9”, 10”, and 13” diameters.

---

BB Series

This frame design is truly a mainstay for general aviation. The strong, sturdy double ball-bearing and ¼” cold rolled steel design will offer you many years of exceptional service. Having a ¾” collar or female thread looking up allows you to simply screw the extension rod into the awaiting threads for easy installation. We offer this frame in 18”, 24” and 36” diameters.

---

BB Extended Series

Use this frame when you wish to have your windsock throat open and ready. This frame also sports a double-ball bearing design and is manufactured beginning with a ¼” steel wire. The extension extends into the windsock approximately 28” which holds your windsock open. It is then painted with an enamel coating. Have a ¾” female thread or collar looking up for installation. Offered in 18”, 24”, and 36” diameters one is sure to meet your requirements.

---

BB Lighted Series

This lighted frame is used when you need your windsock to be seen easily at night. The frame is pre-wired and ready for installation. Be sure to check your local electrical code for proper installation. The cage of the frame extends into the throat of windsock approximately 28" holding the windsock open. As with many of our windsock frames, this design also begins with a " cold rolled steel wire. The double-ball bearing design will offer you many years of trouble free service. It is finish off with an enamel finish. To mount this frame, please have a 3/4" collar of female thread looking up from your mast. We offer this frame in 18", 24", and 36" diameter.